Twin Pierce Enforcers for Hopkinton! First of Two Pumpers.

Hopkinton, MA- Job #38864-1

Congratulations it’s twins for the Hopkinton Fire Department! These new enforcer pumpers are based on the department’s Pierce Aerial (delivered in 2021) and features 750 gal New York style water tank with a  Control Zone side mount 1500 gpm pump. Below you’ll find the weekly progress from the factory floor for baby #1 🚒. (click here for #2’s progress) 

Hopkinton FD's Enforcer Pumper Features

  • Cab: 6000 Enforcer
  • Axle, Front: TAK-4® 19,500 lb
  • Axle, Rear: 24,000 lb Dana
  • Engine: 450 HP Cummins L9 Engine
  • Transmission: Allison 6th Gen, 300 EVS P
  • Bumper: 19′ Extended Painted Steel
  • Water Tank: 750 Gallon New York Style
  • Compt, Pumper, Rear: 30.75″ FF lap Rear Compt
  • Compt, Pumper, Left & Right: 152″ lap Full Height Front & Rear FDLER
  • Pumphouse: 45 Control Zone Side Mount
  • Pump: 1500 gpm Waterous CSU
  • Crosslays: 1•50″ Standard Capacity 
  • Foam System: Husky 3 Single Agent 
  • Foam Cell: 20 Gal 
  • Body: Medium Aluminum 2nd Gen Pumper
  • Chassis: Enforcer

updates from the factory floor!

September 23, 2023: This week the cab began fabrication! Next week the cab may continue the fabrication process.

September 30, 2023: This week the cab completed fabrication and began the paint process. Next week it may continue through paint.

October 7, 2023: This week the cab continued through paint, the pump house structure began fabrication, and the body was fabricated! Next week the pump house structure may continue fabrication. 

October 21, 2023: This week the cab continued the paint process. Next week the cab may continue through paint, and the pump house structure may begin initial assembly!

October 28, 2023: This week the cab continued the paint process! Next week the cab may continue through paint, and the pump house structure may begin initial assembly.

November 4, 2023: This week the cab and pump house continued initial assembly, and the body continued through paint. Next week these processes may continue. 

November 11, 2023: This week the cab continued initial assembly, the frame build began, the pump house completed initial assembly, and the body completed paint and began initial assembly! Next week these processes will continue. 

November 18, 2023: This week the cab and pump house were installed on the frame, followed by the body being merged. Next week the apparatus may complete initial assembly and begin final assembly!

December 2, 2023: This week the apparatus completed initial assembly followed by the start of final assembly! Next week final assembly may continue.

December 8, 2023: This week the apparatus completed final assembly and released to test! Next week it may complete testing and release to quality and graphics.

December 16, 2023: This week the apparatus completed testing and released to quality and graphics where any remaining content will be applied. Hopkinton Fire Department’s new Enforcer Pumper is complete!